Question about Freezer 12 Facing Straight Glass Front Ice Cream Dipping Cabinet - With Rear Storage Doors
...on the door and after closing it, see where the scrub marks are. If it's the lock, take out the striker plate and using a chisel, make the cut out deeper. Install the striker plate and test it
...striker plate/bar is in alignment with the door latch slot. 2. That the striker plate/bar attaching screws are secure. 3. That the door hinges are secure and in the proper position. 4. That the latch ...
...striker plate from the door jamb by backing out the two screws with a Phillips screwdriver in a counter clockwise direction.Install the striker plate that came with lock kit with the screws provided ...
...adjustment can also be affected by the position of the lock striker plate. Loosen the striker plate bolts and move the striker plate just enough to permit proper closing and locking of the
striker plate. Loosen the striker plate bolts and move the striker plate just enough to permit proper closing and locking of the door. TO ADJUST ON A: F-150, F-250, Expedition and Navigator HORIZONTAL
Question about 1997 F350 Crew Cab
...striker plate and tighten.4.ake the two halves of the doorknob, and place the one with the male end through the hole in the striker bar. Place the female side of the doorknob on the other side of the ...
need new hinge pins but i need the metal fixed first i would weld the metal add a plate behind the striker you may need to remove a washer and weld that to stronger medal outside the cracked area
...striker plate on the jam. follow previous advice "check hinges for looseness. Then the easiest way for a novice to fix this is to remove the striker plate and realigning it with the bolt.(be prepared ...
Question about 2001 Jimmy
...that when the door closes goes into a slot to signal door is closed. is black and held on by 2 star bolts The door latching mechanism closes around the striker plate, or striker, or striker
...striker plate. It will close but it is much more difficult to open. I have seen the posts where people jack up the door if it is too low, but mine is too high. I have tried hanging on the door, but ...
Usually answered in minutes!
256 Questions
322 Questions
159 Questions
188 Questions
143 Questions