Strap Wrench 303-D055 (D85L-6000-A) or equivalent to hold the water pump pulley (8509) while removing the four water pump pulley bolts. Remove the water pump pulley from the water pump (8501) . Remove
...remove carpets and side carpet, remove filler neck and screws. Hoist car securely, undo the tank straps, fuel lines (catch fuel that spills out, nip the fuel lines with wrench. Undo exhaust rear ...
...wrench to loosen, then remove by hand. From the outside, pull the lamp assembly backwards. If necessary apply a little pressure on the interior screw posts. ACCESS TO LAMPS! Reverse procedure to ...
...strap wrench) 6.Use a breaker bar,front pulley nut is 22mm Becareful at this area, when pulling out the pulley, If it is necessary for you to remove the front radiator. A crankshaft pulley remover ...
...strap type oil filter wrench to remove the filter. There are, however, two other types of filter wrenches you can purchase from your auto-parts store. One is a type of pliers. they have very long, ...
...strap wrench made for that size oil filter, turn counter dockwise to loosen or to the left, if there is not enough room, you may require a cheater pipe on the handle to give you that extra torque to ...
...strap, which is attached to the upper plenum of the air intake manifold and use a socket wrench to loosen the bolts. There are 11 bolts on the upper intake plenum. Remove the upper plenum, which ...
strap that's located on the cars frame right behind the left headlight, in addition left to ground bolt, unbolt the bracket that supports the a/c line. Remove radiator reservoir tank, disconnect belt
...Having a hard time getting to the filter, in a tough spot, any suggestions? Strap wrench won't fit they make a socket that will go on your 3/8 ratchet then add an extension you should be all ...
Usually answered in minutes!
1,587 Questions
1,450 Questions
1,309 Questions
1,122 Questions
1,306 Questions