Questions & Answers for: GMC strap wrench

...threads. You need to use a strap wrench to hold the pulley. Or make one by using a old leather belt. Just wrap the belt around the pulley. Put one end through the belt loop in the opposite

...WRENCH FIRM YOU REMOVE THE FUEL LINE NUT ON BOTH SIDES OF THE FILTER AS YOU LOOSEN THE NUTS FUEL WILL START DRIPPING FROM BOTH SIDES GIVE IT A MINUTE OR TWO .THE MOST THAT COMES OUT OF THE LINE WILL ...

wrench you will round the corners off. Some came with an adapter fitting and you will need one for backup and one to loosen, they are different sizes so you don't get the lines mixed up. When removing

strap with a metal line feed in the back and the front.put wrench on the housing nut and a wrench on the line comming in to filter losen the nut on the line side, holding the filter firm,break fitting

do I need any special tools? You may need a tool (such as a strap wrench or clutch fan tool) and a large wrench to remove the clutch fan from the snout of the water pump, I believe it loosen clockwise

...the tank if u drop the tank there is a ground strap that goes to fuel pump, this ground is attached at the top of frame 13mm wrench to remove the bolt. the pump wont run without this ground hooked ...

loosening the nut between the fan and pully; to replace the water pump.can't seem to get a good grip on pully to turn the large nut. a strap wrench should do the trick. there not that expensive.

...for draining the tank, that is more difficult-you will have to drop the gas tank and tank support straps. Not something you want to do at home.A lift hoist will be more safer and the proper way of ...

...WRENCH OR STRAP WRENCH TO HOLD WATER PUMP PULLEY WHILE LOOSEN WATER PUMP PULLEY BOLTS .YOU CAN BUY STRAP WRENCH OR RENT PIN SPANNER WRENCH AT AUTO ZONE PARTS STORES OR OTHER STORES HAS TOOLS CAN BE ...

wheres the fuel filter located at There are two.  One is a 'sock' on the end of the fuel pump (in the tank)  the other is a 'can' strapped to the frame.  On my extended ...