Questions & Answers for: Honeywell stoves

furnace tries to come on then .... hold -AC. I burn a coal stove during the cold months and when the weather breaks, I switch to an oil furnace. I tried to trun it on the other day and it would run ...

I replaced an old two wire with the rth2310b. It controls a pellet stove. Seems to be short cycling, the stove no sooner gets going then it shuts down. Could this be because of the heat cycle per ...

We have checked everything, Furnace, dishwasher, We have checked everything, Furnace, dishwasher, breakerbox, stove, sprinkler system,and outdoor outlets. the odor is very strong in the livingroom ...

...R and W. this is for heat thermostat control only. Turning on/off is not possible on all pellet stoves, so this will depend on your pellet stove. Check with the manufacturer of your stove to see ...

solid fuel stove linked to oilsystem with two zone solid fuel stove linked to oil system with two zone heating and hot water zone how do i wire stove stat to open motorised valves without turning oil ...

Trying to hook up a RTH2310B thermostat to a wood pellet stove with only two wires.. How do I know where to connect them too? Hey Brad432, this is what i did with the same RTH2310B thermostat and my ...

have a pellet stove and a thermostat can be hooked up to it. there are only a place for two wires. but i don`t know where to wire them on the thermostat rth2310b You will use thermostat wire and use ...

Is there a recall on Honeywell gas valve on whirlpool gas hot water heater? No, the the defective valve is only on gas fireplaces and stoves, not hot water heaters.

I have a Honeywell CT87K thermostat. I wish to REVERSE it's functionality The thermostat controls a fan above my stove blowing warm air OUT to the basement. In other words I want it to be ON when it ...

Wiring New thermostat Honeywell RTH2300/RTH221 for a two wire pellet stove Red and white