Question about 7901-1 ProHeat Scotchgard Upright Wet/Dry Vacuum
unit: Base - I removed the base cover so I could see the lines and the pump. Everything looked ok, the lines had fluid in them but I could see that fluid was not moving through them when I pressed the
stop after running for from few seconds to 1-2 mins. It stops and the power light is flashing.. I need to remove the battery and put it back in, then it will be able to restart. Could you tell me what
...unit, but no change occurred as a result. Step on the blue lever at the base of the floor attachment to separate it from the long wand. Sometimes there is a clog inside at the base that needs to be ...
...out of the base unit aswell as the iron itself? I have the same problem with my breville steam iron vin no 153 steam and water leaking out of base and iron not heating up like it should can you ...
Question about DC28 Animal Bagless Upright Vacuum
...stop flashing...any advice? I bought it out of country so I have no warranty (so much for me saving over $100 in price!!) try to reset or find the reset button it means the trouble about the string ...
Question about 25512/ 25513 Progressive Canister Vacuum
...condition, Inspect for plugged air flow issue. the motor will burn up, if no heat based interrupt stopped the unit. My bet is that something is plugging the machine's air
...base and reattach it to the tank. This should stop it from leaking. The formula tank on the back has the same gasket so you can pull that out and see how it should fit on. Hope that ...
cannot determne where it should be placed for assembly. Does anyone have an image of the switch assembly with respect to spring placement. Springs should be for holding top base to unit. Hook anywhere
Question about DC40 Multi-floor Vacuum DC40
base unit does not. I have checked all filters, the hose and connections for blockage, etc. The brush is rolling. Electrolux EL 8802 Precision Brush Roll Clean some vac's have a small slide that stops
Question about DC40 Multi-floor Vacuum DC40
unit.Out of warranty you have to be creative. On the Crosswave the roller stopped revolving. I suspected the belt, but was told the "entire" base is replaced when the belt breaks. THAT'S CRAZY. I took
Usually answered in minutes!
1,132 Questions
1,137 Questions
870 Questions
836 Questions