Questions & Answers for: HP sticky rubber

...rubber to make them sticky again instead of smooth. Try the printer.If that doesn't work, make sure that there is no paper or dirt obstructing the sensors above the feeder tray or around the back of ...

...rubber to make them sticky again instead of smooth. Try the printer If that doesn't work, be sure to check that there is no paper or dirt obstructing the sensors above the feeder tray or around the ...

rubber on the feeder is worn and does not pull in papoer properly Try cleaning the rubber rollers with some alcohol, this will often cause the rubber to regain it's "stickiness" and help grab the ...

...sticky cleanser-unit (esp the rubber, gears n base).. also chance of defective/faulty photo/opto-coupler 'sensor(s)'..the diodes and resistors in dis section.. always better to hv professional ...

...the rollers that take the paper in with a window cleaner, you these sprays you can get to clean windows, they are good because it will bring back the sticky touch to a rubber roller. hope this ...

...the sticky gook up with an alcohol soaked piece of cloth. Wear rubber gloves because you can't avoid getting the ink on you. Replace with a new cartridge. Turn the printer off then on. Do a test

rubber rollers on my HP LaserJet 6P are "melting" on the back side of the paper as it feeds thru, creating a black sticky mess. I think that you passed the time to install a maintenance kit.

sticky. Remove the old keyboard key by putting the tip of your fingernail underneath the top right of the key you want to clean. Lift the key upward to remove the key. Push the hinge into place on the

...HP laserjet 6P, works perfectly. only the rubber rolls on the backside are sticky and leave lack marks on the paper, what to do? see above Try cleaning the rollers with a cloth and methylated

...You can also try cleaning the rubber feed rollers with soapy water on a cloth. Rinse with a clean wet cloth and leave to dry naturally. This leaves them a little sticky to grip and feed the