...stereo off? Why would I want to use Standby instead of powering it off entirely? Standby mode does not completely power down the unit it jsut does not draw as much power as when the unit is on. Also, ...
...receiver while he was sleeping on it. I was watching tv when it just shut down. I turned it back on and it made a zap sound then began blinking the standby light. Hi...1st off ...make sure all the ...
...Stereo Receiver won't turn on. Yamaha R-700 Natural Sound Stereo Receiver. It won't turn on. No lights just a single click after about 10 seconds. Similar single click when switching power off. Both ...
Question about TX-SR705 Receiver
...my reciever on or off. the standby light is on and i don't get anything. The stereo doesn't turn on or off. Try to use the control panel switch to turn on. Or maybe your remote battery need a new
stereo goes into standby when powdered up. I then have to unplug it and the same thing happens again Check the speaker connections. There may be a short. If not most likely there is a blown output ...
...stereo standby stay on stereo wont play through speakers Hi, is the red light that says power On? If not, it could just be the fuse since I had the same problem. If you take the lid off, it should be ...
...stereo receiver is stuck on standby mode regardless of power cycling or any attempts to play audio. Does it power up or straight to standby? If it is on but in standby it could be speaker protection ...
...stereo beacon, no sound Worked up until a month ago. no changes whatsoever in hookup. Hi... try factory reset: while holding down VCR/DVR button ,press the ON/STANDBY button. "Clear" will appear on ...
...receiver. On 6 ohm mode works fine. I tried with 4 ohm stereo speakers,6 ohm stereo speakers and without any speakers. No diference. Seems like a protection starting to work,but there is no shortcuts ...
Question about Sta-3900 Stereo Receiver
...stereo reciever that wont turn on. Standby light is on. Tried resetting it from the back but didnt work. Please advise A standby condition can mean a fault in the receiver. voltages in the system are ...
Usually answered in minutes!
687 Questions
481 Questions
236 Questions
236 Questions
240 Questions