Questions & Answers for: Geo Tracker starter motor

...gear on level ground, release the parking brake and rock it vback and forth. This should dislodge a jammed pinion. Try starting again and see if this dislodges the starter motor. Hope this

...starter motor just gives one loud click. the battery is well charged and nearly new . the conections are good . I wired the starter to a switch my self but i was only using comon sence to do so, it ...

...motor over thus the clicking. Try charging the battery or jumping, if you still get a clicking it would be the starter solenoid. Considering the year you may just want to replace the whole ...

Starter motor will not run, I hear clicking of a relay under the dash when I turn the key to start. But the solenoid is not pulling in. try to jump start and see what happens.If it does not start then

starter motor unit, matchmark the solenoid-to-starter motor housing position, as shown in the accompanying illustration. Remove the starter motor from the vehicle. Detach the solenoid-to-starter motor

...starter motors is ok, if not motor. Can you trun the engine over by hand? Check the ground wire.  Mine was grounded to the finder housing.  I cleaned the paint from under the lug and it ...

...motor for a 93 geo tracker for the starter and alternator putting in 1.6 motor into my tracker and need to know how to hook up starter and alternator old post is this an electrical question? the ...

starter on 93 geo tracker motor 1.6 old post. which engine, 8valve TBI or 16v MPI? but works on all cars with , 1 more step. 1: pull battery neg. lug, first, or boom, eat acid/go blind, etc. 2: remove

...motor over when the ignition key is turned to START. The battery has been replaced as well as the battery cable to the ground. The positive lead has had all the battery connector replaced at the same ...

...one car of mine, 3 times in 250k miles. I'm a skin flint . Striking a starter is not good because it can break or dislocate the magnets in the starter motor. Recheck all connections for