...fron a relay under dash listen for that and if u hear a click then u need to replace solonoid on starter or replace whole starter motor also clean and inspect battery cable good luck with this ...
...starter motor. The hold-in winding circuit is completed to ground through the solenoid. The windings work together magnetically to pull in and hold in the plunger. The plunger moves the shift lever. ...
eng wont turn over need more of a discription ,, does the starter turn the motor?
Chevrolet Venture 2002 Does not Start I turn the key of the ignition, the starter tries to turn on the motor, but does not do so. Seems like the gasoline is not going in the engine. not enough info
...starter motor on 2001 venture easiest way to find it is jack up the car and get under it. its usually towards the front of the car on a venture, you don't even WANT to know! But it's in the back left ...
starter motor. The starter motor is serviced only as a complete unit. Disconnect the battery ground (negative) cable from the battery. Raise and suitably support the vehicle. Refer to Vehicle Lifting.
...Bad starter Relay? Use Voltmeter check voltage going to main starter wire while someone cranks the motor if not power check power to starter relay while cranking if no power suspect ignition
...If the battery is good and you get a click sound then it could be the 'bendex' at fault. It is that part of the starter motor that pushes and pulls the starter piniin to mesh with the flywheel
...starter motor on the front of the engine, working from under the van. Remove the retaining nuts from the terminals on the back of the starter solenoid with a socket and ratchet then label the wires ...
...starter motor make sure all the connection including the negative connections are clean and making good contact. Once that has been done and still no improvement go for the starter motor. Regards ...
Usually answered in minutes!
776 Questions
608 Questions
549 Questions
460 Questions
342 Questions