Questions & Answers for: start relay

...relay keeps a start capacitor in the system for a minimum of 50% of BEMF and a maximum of 80% of BEMF, the potential relays coil between terminal 5 and 2 are rated 120% of BEMF for continuous rating. ...

Ad

...start relay, but it does not clicking sound. Then thought it was the over load relay. I see Sears Parts Direct sells the 1st for $36.53 and the overload for $40.86 and a Grommet for $5.03. If its ...

Ad

...start light go out and you hear click under dash area like relay, no power getting to starter. happens intermittently - remove battery cable let sit for a bit . starts right up . happened twice to my ...

Question about 1999 Windstar

1 Answer

...start seems like no fuel,how to test fuelpump? If you don't have fuel pressure test equipment then try spraying engine starting fluid in the air cleaner if it starts then you probably have a bad fuel ...

Question about 1999 Windstar

1 Answer

...start side of the relay (small wire) with key in the start positon, then your starter switch is faulty (under dash usually mounted on top of steering column). 5. If you have voltage to the start side ...

Question about 1999 Windstar

1 Answer

...start side of the relay (small wire) with key in the start positon, then your starter switch is faulty (under dash usually mounted on top of steering column). 5. If you have voltage to the start side ...

...supply ? check you fuel pump relay. located on IPDM marked as ECM relay in the picture. Just change places of ECM RELAY and FOG LAMP relay and try to start. If it starts change the ECM relay. good ...

...relay being bad make your car not start sometimes Relays rarely go bad. If you have on that gets really hot. It could be the relay or the wiring. And yes, main relays and even secondary relays can ...

...relay will start to click fast and then they'd slow down and stop,then it would start,but now the relays won't start clicking at all Could be corrosion. The ASD runs all the others. Start by pulling ...

START relay coil supply voltage input terminal of the engine control module (ECM) and the coil side of the START relay. Placing the ignition in the START position sends a message to the ECM requesting

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Freezers Experts

Brad Brown

Level 3 Expert

19187 Answers

ADMIN Eric
ADMIN Eric

Level 3 Expert

39381 Answers

ADMIN Andrew
ADMIN Andrew

Level 3 Expert

66931 Answers

Are you a Freezers Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...