standby...won't turn on or anything...it worked fine but now it won't...any suggestions??? had the same problem and did th Push the Advanced Surround & Enter buttons at the same time for three seconds
...STANDBY/ON button for about three seconds. 3. When you see RESET? appear in the display, press the ENTER button. OK shows in the display. 4. Press SETUP to confirm. OK appears in the display to ...
...STANDBY/ON button, The receiver will shut off before the AMP ERR comes up. Then hold the TONE +STANDBY/ON button until the screen says reset. then press the TONE button, the screen will ask you to ...
Question about VSX-D912 Receiver
...Standby LED Flashes. When I press the power button, the receiver will not come on (display is blank). I have tried unplugging it for a long time, but when I plug it back in, it is still stuck in that ...
start?? By touching by acc. it 's reloading the accum. go to standby mode and press the preset 5 or 6 button. the unit should tell you which button you need to press when you go to standby on the deck
...button on the hardware unit and keep pushed in Push in Standby button on the remote provide while doing the above Then put into standby mode again insert your DVD and see if it changes. All ...
...STANDBY/ON button for about three seconds. 3 When you see RESET? appear in the display, press ENTER . OK? shows in the display. 4 Press SYSTEM SETUP to confirm. OK appears in the display to indicate ...
Question about PDP-4270HD 42 in. Plasma Television
...standby button is pressed on remote control for split second the blue light comes on then back the standby mode Try restting it by unplugging the tv for a few mins and it should rest to original ...
Question about New Original SX316S Remote Control
...TONE button, press and hold the STANDBY/ON button for about three seconds. 3 When you see 'RESET?' appear in the display, press the ENTER button. OK? shows in the display. 4 Press SETUP to
Standby" button simultaneously until "Reset" and "No" appears on your display. Use the "Preset" arrow buttons to make the display say "Reset" and "Yes" . Press the "Enter" button on the front panel to
Usually answered in minutes!
169 Questions
146 Questions
83 Questions
90 Questions
66 Questions
