...standby led light is allways on. nothing happens when i press the buttons. there is a small circuit board just for the power, volume and channels button, i dont know but shouldnt this be recieving ...
Question about RZ-20LA70 20 in. LCD Television
...standby button on your Sky remote control. If your TV switches off, press select. The light on the Sky remote control blinks twice (code stored). If your TV does not switch off, press tv, then press ...
Question about MKJ32022813 Remote Control
Tv on standby wont turn on either by remote or buttons on tv Red standby light on tv is on but when I try to switch tv on either by remote or buttons on tv the red light either goes off or the green ...
button standby Standby button red but won't turn on The receiver is in protect mode, most likely due to a damaged amplifier. This protect mode, keeps the unit from turning on and causing further ...
Standby Problem standby will not come off with remote or button, can you help please? its your lcd button problem open and clean it. then your problem will be solve there is a lot of dust in button.
...up once in a while after plugging power I/O many times. Even when the standby comes up it does not turn on the tv from remote or the button front panel. . Kindly help. Could be power supply ...
Question about 37LC7D 37 in. LCD HDTV
button standby light goes off. Screen flashes a green tint and then goes black. Repeats this cycle until I disconnect power. Sounds like T'Con board fault. Please contact the authorized service center
...button once, it is in standby mode. Press the power button once again to exit standby and turn on the TV. Step 2 Observe the Standby light if the remote control will not work. If the Standby light ...
Question about 37LC7D 37 in. LCD HDTV
...button on the remote the standby light goes out. after 20 minutes the standby light comes back on. Any ideas? Thanks Have you measured the various power supply voltages for both DC voltage and AC ...
...button. My tv is on standby and when I use remote or the power button it just gives a clicking noise as if it were going to turn on but doesnt turn on and standby is red. Try a power cycle. Remove ...
Usually answered in minutes!
2,254 Questions
610 Questions
478 Questions
339 Questions
330 Questions