Questions & Answers for: Nissan 300ZX stalls after fueling

87 nissan starts then stalls 87 nissan 300zx starts then stalls fuel pump & regulator are 1 yr. old it will idle but if you tough the gas pedal it stalls jdmbaker: There are a few areas I would ...

'87 300ZX(NON-TURBO) STALLS OUT/BOOGS DOWN will not "idle-up" with breather connected--when disconnected will start,idle, will run up to 2000rpm then stall out--put in/on new fuel pump, new fuel ...

car stalled and will not start 1991 Nissan 300zx twin turbo. I was taking her for a drive when i got a funny smell. After about a minute she stalled and wouldnt start. didnt hear the fuel pump. ...

I change the fuel filter. The 300 zx 1988 after warms up and you are driving it stalls on you it fills like fuel depravation. You put it in neutral and idle and gain power again only to repeat the ...

When at idle the rpm varies between 500-800 (and sometimes stalls). Also, when shifting out of gear, the rpm drops to 100-200 rpm then comes back up. Not sure what it is? Did notice there was a vacuum

My 1986 Nissan 300zx non-turbo was running fine, then just stalled out suddenly and would not restart. I checked the plugs, wiring, fuel, all are OK. I installed a new coil, distributor cap and rotor.

My 86 300zxt starts then stalls right away, it has spark and fuel . I also changed the mass air flow sensor( from junk yard )already someone help maybe tps? There is a two terminal key switch on some ...

...and the acceleration is hesitant and jerky kind of and it seems like it wants to stall out.. and it stalls sometimes.. could it be a bad TPS or Maf Sensor..? please help many thanks.. Well is the ...

car stalls after starting As with any no start issue, you will need to figure out if you are dealing with a no spark or no fuel problem to proceed.Check for spark at the plugs and fuel for the ...

...pressure before replacing the fuel filter. Is it a relay or a fuse? My 1985 300 ZX 2+2 NON Turbo stalls when I accelerate from idle speed. I want to replace the fuel filter but need to disable the ...