Questions & Answers for: Onan stalls after fueling

Question about MicroLite 2500 & 2800 LP Gas Generator

2500 lp starts, then stalls

...stalls My genset starts, then stalls. It then takes 15 minutes to restart it, then it stalls again Unit is over fueling, did you change fuel pump for non OEM part? fuel carb needle maybe stuck with ...

Question about CUMMINS 4.0 KYFA/6747 - Cummins MicroQuite Generator, 4000 Watt, Gas C.A.R.B. 4.0 KYFA/6747

2 Answers

My onan 4.0 generator will not idle and is back fireing while trying to run it will run fine for ten min then starts trying to die and starts back fireing when I try to keep it running

My onan 4.0 generator will not idle and is back fireing while trying to run it will run fine for ten min then starts trying to die and starts back fireing when I try to keep it running check for a ...

Question about CUMMINS 4.0 KYFA/6747 - Cummins MicroQuite Generator, 4000 Watt, Gas C.A.R.B. 4.0 KYFA/6747

1 Answer

It will start if i hold back on the throttle

...if i give it any throttle or if a load is put on it and the govern try to give it more throttle it stalls out Check the entire fuel system, pump pressure, carb bowl for dirt, carb jets clear. fuel ...

Question about Cummins RV QG 4000 Generator, 4000W, Gasoline

2 Answers

RUNS FOR 4-5 MINUTES THEN QUITS. I BLEW THE FUEL FILTER OUT. IT SEEMS GOOD. IT IS JUST LIKE IT RUNS OUT OF FUEL. IS THERE A FUEL PUMP IN THIS UNIT. ONLY HAS 100 HRS ON IT.

RUNS FOR 4-5 MINUTES THEN QUITS. I BLEW THE FUEL FILTER OUT. IT SEEMS GOOD. IT IS JUST LIKE IT RUNS OUT OF FUEL. IS THERE A FUEL PUMP IN THIS UNIT. ONLY HAS 100 HRS ON IT. low oil shutoff,tank ...

Question about Microquiet 3600 & 4000 Generator

2 Answers

Generator not getting gas from almost full gas tank. By passed line from tank and have 1/4 line into gas can, generator works fine. Blew into gas line towards tank and no blockage.

Generator not getting gas from almost full gas tank. By passed line from tank and have 1/4 line into gas can, generator works fine. Blew into gas line towards tank and no blockage. SIMPLE Onan ...

Question about Microquiet 3600 & 4000 Generator

2 Answers

Onan 4000 Microquiet shuts down after running for 20-30 minutes. If I direct 2 high power (400+ CFM) fans to the underside of it -it will keep running indefinitely.

Onan 4000 Microquiet shuts down after running for 20-30 minutes. If I direct 2 high power (400+ CFM) fans to the underside of it -it will keep running indefinitely. check the current draw from the ...