Questions & Answers for: sta 300

...turn the knob to on. I have tried blowing air on it to clean it. make sure that the thermocouple is staying in the flame youmay want to replace it unless it is staing lit on its own until knob is ...

Cold start is fine but after warm start the engine misses and sta I,ve had my 1990 Mercedes 300ce-24 for about 5 years.I've used it daily untill mid-October when hospital treatment meant it was left ...

...300 BAT attaches to the battery charging wire. GRD is ground wire. STA is stator. FLO is probably FLD or field wire connection. It would help immensely if i knew what year and model you were working ...

I changed my cartridges and now the filter will not fill to the top? I have NO pressure on the gauge and no pressure on the relief valve? It sounds like the seal didn't seat properly. Try re-seating ...

My stanley 300 amp jump-start system lights flickering when I plug it in to charge? My stanley 300 amp jump-start system lights flickering when I plug it in to charge? I think the answer is "awe that ...

stanley 300 amp jump-start system status lights don't work. only low stays on status lights dead, except when I hold down battery status button Stanley 300 amp jump-start system status lights ...

my stanley 300 amp jump start system lights flicker when i try to charge ...

...If I disconnect the negative lead...then hook it back up....it comes on briefly but will not sta y on. Could it be the resistor? most likely is the 'resistor' that controls the fan speed. try ...

...300 CE, 24 valve, will not start when cold unless you spray carberator cleaner in throttle body. Then it will start, but will not accelerate until car is warmed up. The cold sta Replaced both coolant ...

sta-300 manual availability Looking for manual download Try Googling (brand)(Sta-300)(manual) without parens.