Questions & Answers for: spun rod bearing

Question about Car Audio & Video

2 Answers

...rod bearing has spun? it can be a spun bearing or the rod itself gets wore out and stretches into an egg shape this will also cause a knock but usually when a bearing spins it will make the engine ...

Ad

Question about 2004 Ranger

1 Answer

...spun a rod bearing it had plenty of oil (full synthetic since first oil change) what causes a rod bearing to get spun? Your vehicle timing chain jumped a sprocket spinning a bearing means that the ...

Ad

...spun rod bearing, and a scored crank I have a spun rod bearing, and a crank replacement -- along with full set of bearings -- is going to have to happen. Unable to locate crank or bearings and ...

Question about 1986 626 Coupe

2 Answers

...spun rod bearing. Spun crank bearings are rare and sound deep. A spun rod bearing can be fairly quiet on idle depending how bad it is worn out, but it will be really loud on acceleration. Piston slap ...

Question about 2003 350Z

1 Answer

...spun a bearing so when i have the car running it is making a knocken sound so could that be my crankshaft bearing or my rod bearing ? if you have oil in you car and it still knocken then it could be ...

Question about 1996 Grand Caravan

1 Answer

...spun a rod bearing. After inspection a discussing with area mechanics, they said I could put a standard bearing in place of the spun one as long as I didnt see any brass on the bearings. So I replace ...

Question about 1996 Grand Caravan

1 Answer

...spun a rod bearing and i am trying to repair it cheap and fast as possible there is some residual bearing that is now stuck onto the top of the crank journal is there any way to remove this enough to ...

Rod #3 had spun. It scored up the crank pretty bad. So I did a little research online and decided to repair the crank in the car by using 400 Grit wet Sandpaper and a thick rope and wrap it around the

Question about 1999 VZ 800 Marauder

1 Answer

piston slap I think I spun a bearing. is this common on these bikes. ok piston slap is down to worn rings, if a bearing has spun this is a biggy, might need new / used crank, and rod.

...how do I find number four it number 4 take another cap off and read the size what you are doing is a short cut to costly repairs as a spun bearing usually requires a new con rod as well as ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Car Audio & Video Experts

xxxxxx xxx

Level 3 Expert

5117 Answers

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Brad Brown

Level 3 Expert

19187 Answers

Are you a Car Audio & Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...