Street Glide Your wheel is 95 to 110 ft lbs Brake Disk is 30-45 ft lbs ( lock tight) Pulley i( belt Sprocket) is 55-65 FT Lbs Lock tight red on both
New Drive Sprockets for the late model FLHX Hey guys, when is HD going to manufactuer a chrome drive sprocket for the 2009 FLHX? When you go to a 2 into 1 exhaust the left side is a little bare and ...
...end of shaft is .006 Flywheels on the truing stand show .0005 at the pinion shaft and .002 at the sprocket shaft Measurments taken on the bearing inner races. If you suspect a bent pinion shaft,
...a runout of .006 With the flywheels on the truing stand the pinion shows a runout of .0005 and the sprocket shaft has a runout of .002 Could the pinion bearing or cases be the cause? Ok, I thought I ...
Question about 2007 FLHX Street Glide
where is the compensator sprocket on a 2007 street glide Hi Anonymous, behind the primary cover bolted to the engine crankshaft. Have nice day.
compensator sprocket removal ans Hi Anonymous, see previous answer. Have nice day.
Question about 2008 FLHX Street Glide
...inner bearing is worn. dealer should have known this. Common enough. It is most likely compensator sprocket. Depending on year the stock one is
Question about 2008 FLHX Street Glide
08' Harley street Glide does not start, battery is good Hi Anonymous, and the usual suspects are: 1. Fuel tank empty 2. Fuel supply valve turned off. 3. Fouled spark plugs. 4. Engine flooded with ...
...on the rear swingarm, move the wheel forward and slip the belt off from the compensator drive sprocket, hold onto the compensator drive sprocket while removing the rear wheel so that the ...
Question about 2007 FLHX Street Glide
What caused the compensator sprocket shaft to loosen and destroy the rotor? Could not get it to start. Took the primary apart and the shaft for the compensator sprocket was loose, causing the sprocket
Usually answered in minutes!
644 Questions
133 Questions
72 Questions
82 Questions
68 Questions