Questions & Answers for: Isuzu Pickup sprocket supply

...on door pillar. Failing that strip down to the cambelt,see if you can identify marks on cam,crank sprockets and corresponding marks that they align to on block and head.it's good to paint mark the ...

...forward the associated pictures & info to you. Jim Young [email protected] TIMING BELT & SPROCKETS R & I NOTE: Some procedures may differ slightly due to engine construction. Removal

the truck cranks but takes a nose dive when you try to drive or accelerate. It has been sitting for about 4 years check fuel supply(pressure) it sounds like its not getting enough fuel, check fuel ...

How can i tell if i have a blown head gasket and is there a difference in cracked\warped head or blown gasket when diagnosing? Hard to tell if its a blown head gasket or warped cracked head. The ...

WHERE IS THE RELAY LOCATED AND IF THE PUMP DONT PUMP WHEN CONECTED BUT PUMP ON DIRECT CONECTION TO A 12V POWER SUPPLY CAN IT BE A RELAY PROBLEM (FUSES OKEY) Yes if the pump works on direct connection ...

timing belt TIMING BELT & SPROCKETS R & I NOTE: Some procedures may differ slightly due to engine construction. Removal 1) Remove all necessary air ducts. Position No. 4 piston at TDC of ...

i have a 1986 isuzu pickup with 2.3 eng i cant find the timing mark on the oil pump pully where is it Oil pump has no timing mark. Just get the crank and cam marks aligned. Make sure the belt is tight

I have an Isuzu KB260 4x4 On how many degrees before TDC should the timing be. isuzu engines has timing marks. normally the piston #1 is set at TDC then the camshaft sprockets marks must match up the ...

engine surges I have a 2003 KB300 TD double cab. This vehicle surges (almost like you have been rear ended but no accident) while driving. Usually when RPM's are close to 2,000. This vehicle is also ...

...to set the engine at TDC/compression stroke for the #1 cylinder. The arrow mark on camshaft sprocket aligns with mark on the rear timing cover. Links below may help in setting the timing. To ...