Questions & Answers for: Saturn sprocket

Correct position of the camshafts and cranksharfts for timing of my 99 saturn SL2 the cam shaft sprockets have marks on them that say" front" and have a hole,, the marks should be up and level on the ...

Ad

...Install the special oil seal replacement tool SA9104E, to be sure the front crankshaft timing sprocket is held firmly in place and prevent guide damage. Install with the flat side towards the ...

Ad

Question about 2001 SL

1 Answer

need a picture of crank sproket's showing both inner n outer sprockets with a correct alingment to the t chain 2005 ion redline 2.0 sprchrgd ed.. Fig. Install the balance shaft chain with the colored ...

Question about 2001 SL

1 Answer

...be no more than 16.77 in. (426mm). Inspect the chain guides for wear or cracks and the timing sprockets for teeth or key wear. Replace components as necessary. Verify that the crankshaft is ...

Question about 1998 SL

1 Answer

dont no how to set the timming and what it suppose to be Timing Chain and Sprockets REMOVAL & INSTALLATION Fig. 1: At 90 degrees past TDC, the crankshaft sprocket timing mark and keyway will align

...Disconnect the negative battery cable. Remove the timing chain front cover. During timing chain and sprocket removal, position the crankshaft 90 degrees past Top Dead Center (TDC), to make sure the ...

...for the intake and exhaust cams To Install: Install or connect the following: Timing chain drive sprocket to crankshaft Rotate the crank so the mark on the sprocket is at the 5 o'clock position ...

crankshaft timing mark. The other silver link should then be aligned to the mark on the exhaust cam sprocket. See picture below. For the 3.0 liter engine, there are marks on the belt that line up with

i need the timing mark diagram for chev 2.2 dohc eng. Timing mark on the cam sprocket is on the web between two of the holes. The timing mark on the crank sprocket is a small dot on the tip of one ...

How to set timing on 03 Saturn vue without using timing marks I think the previous owner did work on the valves and did not install a gear correctly. So the timing mark on that gear don't line up This

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

1999 Saturn SL
1999 Saturn SL

1,310 Questions

1998 Saturn SL
1998 Saturn SL

953 Questions

2003 Saturn VUE
2003 Saturn VUE

1,183 Questions

2000 Saturn SL
2000 Saturn SL

963 Questions

1997 Saturn SL
1997 Saturn SL

862 Questions

Top Saturn Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

john h

Level 3 Expert

29494 Answers

Are you a Saturn Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...