Questions & Answers for: spring turn on

Ad

...spring has been installed, turn engine backwards to relieve tension on line you installed and remove all of lit from cylinder. Replace rocker, and adjust per specs. (usually 1/4-1/2 turn down after ...

Ad

spring was turning when i turn the wheel you did not locate the springs in the latched postion and struts will turn some thats why there is a strut bearing at the top it is possible to get the springs

Ad

Question about , No.455 Rancher, 20" Gas - Powered Chainsaw

1 Answer

...spring. Make sure to turn it CCW to wind it, but leave enough slack so that the spool can turn about four more turns without binding the spring when starting. If the cord broke, the spool may have ...

Question about 1989 Continental

1 Answer

...TURN OFF AIR SUSPENSION SWITCH.THEN REMOVE AIR SPRING SOLENOID RETAINING CLIP,ROTATE THE SOLENOID COUNTERCLOCKWISE TO FIRST STOP, THEN PULL SOLENOID STRAIGHT OUT SLOWLY TO THE SECOND STOP UNTIL ALL ...

Question about 1989 Continental

1 Answer

Cratftsman Lawnmower; 16.5 horse; 42 inch deck, need assistance replacing armbrake and tension spring #58 on sears schematic; MOwer model number is 917271120-- particularly, where does this spring ...

Question about 1989 Continental

1 Answer

...spring in place, turn the rewind in the direction that it turns when you pull the rope until it stops, then release one turn and insert rope thru guide and into spool to tie knot. Slowly let rewing ...

...clanking sound under car upon turning steering wheel sharply or boinging sound like a metal spring letting go. Sounds like the strut spring may be turning within its mounting brackets when

turning until the spring is tight, back off about 1/2 turn and feed the rope from the outside, be carful here, if the extecsion comes out the spring will uncoil and you get to start off all over again

Question about 1999 Venture

1 Answer

...turn till spring is fully wound ( can't wind anymore without force) then back it off until the rope holes line up. Install rope and handle and retract slowly. Pull handle a few times to make sure its ...

...spring winding up and trying to turn back against you this will tell you if the spring has not broken, if not the spring has broken and will need to be replaced, remove the centre screw holding the ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

Marvin
Marvin

Level 3 Expert

85160 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

john h

Level 3 Expert

22181 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...