Question about Hardware & Accessories
...spring hinge on my door pulled away from the door frame. How do I release the tension to fix it? If there is a cylinder on top of the hinge with small radial holes in it, you need to find a way to ...
Question about 1994 Silverado 2500
...door hinge spring with a heavy towel. Using tool J-36604 or its equivalent, insert the blades of the tool between the spring coils and turn the barrel nut to compress and hold the spring. Remove the ...
...door with hinges on the bootom of the oven door, then it is likely to be weak door hinge springs, the usual solution is to replace both hinges. If it is a swing open door, then the problem is related ...
...spring or hinges in the door tHE DOOR SPRINGS ARE BROKEN. IF YOU HAVE DROPPED THE DOOR TOO MANY TIMES THE HINGES MIGHT BE BENT TOO. yOU WILL PROBABLY NEED HINGES AND SPRINGS....A bit of a job for a ...
...door spring by using a door spring removal tool. Insert the tool into the door spring, turn the knob with a screwdriver to compress the spring, then pull out the tool. 3. Set a 5-gallon bucket under ...
door was fully open, lift hinge until it stops at broiler position. CAUTION- THE HINGES ARE SPRING LOADED AND CAN SNAP BACK INTO FULLY CLOSED POSITION. You can use a heavy glove or if you have an oven
door it is out of alignment spring on bottom fell out. I have to push down on door in order for it to close properly. How hard is it to re align the hinges and put the spring back in I am not familiar
...door does not spring shut. Can I adjust something in the hinge or do I need a new part? Thanks chk the spring and the door hinge. it is probably the hinge-spring that is broke, or slipped out of the ...
...door hinge spring I found the spring, but and understand it takes a special tool. Looks like a bent screwdriver. How do I use the tool? A door hinge spring compressor such as ...
...door spring, old hinge pins and bushings: 1.Remove the retainer clip on the top of the top hinge pin with a screwdriver and pliers. Start to wiggle it loose with the tip of the screwdriver and then ...
Usually answered in minutes!
397 Questions
305 Questions
125 Questions
102 Questions