Questions & Answers for: Pontiac Grand Prix spout connector located

...located on the side of the throttle body (indicated below), and there are 2 Torx head screws holding it in place. You need to disconnect the connector from the TPS first, by lifting up on the tab ...

...located on the exhaust manifold and on the exhaust pipe before the catalytic converter Identifying HO2S1 sensor connector?3.1L, 3.4L, 3.5L, 3.8L (with NU3) and 3.9L engines Identifying HO2S2 sensor ...

...located below the Assembly to remove headlamp assembly and access signals: -open the hood -while pushing rearward on the headlamp,pull up half-way on the (white)plastic retaining clip on the ...

...connector wire located in the RH trunk area. You may have to pull back right side trunk trim on trunk wall to locate the single black/white wire. 2. The programming connector wire should have one ...

...located under the ignition coil packs, follow the spark plug wire''s from engine to coil packs. If you have a 3.1L engine, the module will have three connector, two one one end and one in the other ...

...located on the blower motor housing, it is the part where the electrical connector goes into and it's got a pigtail connector that goes to the blower motor, it is attached to the blower housing by ...

...connector. (you have to disconnect both the front and rear washer motor connectors to get this one off) It is located near the fill spout of the washer tank (Left side of engine compartment). Third, ...

...located by the blower motor on the passengers side under the dash.Just listen for the blower motor.You may have to remove a lower dash panel to see under the blower motor.Then just follow the 2 wire ...

drl location 2006 grand prix Looking for location of drl module in 2006 grand prix  Pont Grand Prix; has 16 pin DRL module, fuse removes DRLs and Auto-ON (there is also a fuse for air bags, SRS) ...

...connector located for the blower for heater Blower does not work, I want to check the connector for corrosion. If it is not the fuse it could be one of two things. One is the switch. This is the one ...