...line time the 302 and I can't find the spout to disconnect the computer on this 88 ford crown vic. Sisters car had loose dist. lock bolt the spout connector should be in the harness at the ...
...connector located above the cross member underneath the vehicle. Step 5 Disconnect the vapor tube from the tee connector on the right side of the car-passenger side-and the vapor line from the ...
location of EGR valve for 4.6 liter engine? how do you remove the EGR valve? EGR VALVE IS #2. Please wait for second post to answer your second question....comes with a few pictures. Raise vehicle on ...
connector located above the cross member underneath the vehicle. Disconnect the vapor tube from the tee connector on the right side of the car-passenger side-and the vapor line from the canister tube.
Question about 1988 Crown Victoria
...located on a 1988 crown vic with a 5.0 liter fuel injected motor attached to the throttle body,looks like an electric motor bolted to a square piece with the corners notched out,with 2 wire connector ...
horn does not work 97 crown victoria FIRST I WOULD CHECK THE HORN FUSE OR RELAY ...CHECK YOUR OWNERS MANUEL TO SEE FOR LOCATION PROBABLY UNDER HOOD IN A RELAY STATION BOX.IF THOSE ARE GOOD..THEN ...
connector that goes to the trunk release. The harness is located near the left hinge. The wires going to the harness go around the hinge. The connectors are difficult to seperate because you can't see
Question about 1985 Crown Victoria
...code 18 mean on a 1985 ford crown victoria? 5.0 engine code 18.what does it mean? Code 18 is a spout circuit problem. You probably need the flow chart to check all of the components in
Obd location Connector location Should be under the dash on the driver side.
where is the data link connector location located on the drivers side under the dash usually to the left of the steering colume.
Usually answered in minutes!
454 Questions
486 Questions
323 Questions
297 Questions
294 Questions