Questions & Answers for: Chevrolet TrailBlazer EXT spout connector located

Question about 2006 Trailblazer Ext

1 Answer

how do i replace the passenger headlamp how do i replace the passenfer headlamp? From under the hood go to the back of the light,unplg the connector,unsrew the plastic ring holding the bulb in,remove ...

Ad

Question about 2003 Trailblazer Ext

1 Answer

Headlight went out and the fuses look good. Manually can't turn them on. check the head light switch for burned/discolored contacts, if they are replace the switch and the switch's connector, avil at ...

Ad

Question about 2006 Trailblazer Ext

1 Answer

heater blower stops working on high Check the blower motor resistor module,it is on the passengers side by the blower motor.Make sure and check the connectors to.They get hot and will melt ...

...connector on drivers side of shroud. Take top radiator hose off of radiator, move it out of the way. Loosen, but don't remove fan clutch to shroud bolts 4ea 13mm. Using a fan clutch tool loosen the ...

Question about 2005 Trailblazer Ext

1 Answer

I have no low beam headlights. The high beams work and I have changed the switch and bulbs and checked the fuses. what next Check the connectors that go to the headlight bulbs to see if they are ...

...located on the left rear of the engine block below the starter. it has an oval connector and is held in place by one bolt. See picture of sensor below (some models has a 45 degree connector, most are ...

WHILE DRIVING LIGHTS WILL CLICK OFF ON MY 2002 TRAILBLAZER WHAT COULD CAUSE THIS A defective light headlight switch would cause this problem and is common on older models like yours. Pull the ...

Question about 2003 Trailblazer Ext

1 Answer

one headlight works sometimes someone spliced the receptical and one end of the wire connector was out. I put another connector on and the light worked. It stopped working and I thought the connector ...

Question about 2005 Trailblazer Ext

1 Answer

plugging the wires fromwire harness i have some loose wires to plug up wires in a harness are colour coded and the connectors will be alike so find the same wire code and plug the connectors together

Question about 2003 Trailblazer Ext

1 Answer

How to fix code B0044 1. This code refers to a problem with the steering wheel stage 2 air bag circuit. 2. Disconnect the dual stage air bag connector at the lower steering column. 3. Substitute 2 ohm

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...