Questions & Answers for: RCA split second

...split second, the green light too, then shuts off, then it tries again in a second or two. I have ruled out the fuse as I would not get any poer if it was blown. Is this the HV Splitter? If so can a ...

...second picture in Picture-in-Picture (PiP) I've gone through all my inputs. But, I still don't receive any channel in my PiP screen. I can watch my DVD player and another channel on TV, but I can't ...

Split Screen Some how my progressive scan got turned on and i can not figure out how to turn it off. On the screen it say's pscan on. Please Help!!! Chris Go into SETUP GENERAL SETUP PAGE Go to VIDEO ...

...second receiver. Cannot just split signal. With some cable providers you can split the cable before it hits the cable box for basic cable channels. Suggest contacting Cable Company if does not work. ...

...under Artist, that start with the Letter "K" sometimes it'll have entry for each album sometimes it splits it up even farther and mixes them up. Double check the RCA forums, but I think it is a flaw ...

...split second, [USB Connected] flash on my player screen before disappearing. About three seconds later, it does it again. It shows no signs of progress and, after disconnecting it from the cord, it ...

...split second then I heard a pop and it went out. I haven't been able to turn it on since. Did I blow a fuse or what? Can it even be fixed? YES CHECK FUSE AT REAR PANEL - MUST REMOVE THE FOUR SCREWS ...

...split second and goes out. If I wiggle it back and forth and it and out I can't get it to ever find a spot where it stays on. Is this repairable? the sound source MUST be hooked up and running ...

...split second every 20-30 seconds. Check the small signal boards solder connections. The small signal board is the large green circuit board on the right when looking in the rear ( Has all the inputs ...

...for a split second. Can see screen with flashlight test. This happened once before several months ago and worked fine when I unplugged for a few minutes and plugged back in again. Your LED ...