Questions & Answers for: spider shaft

Question about RAS8445KQ Top Load Washer

1 Answer

...spider to the input shaft of the gearbox and the motor shaft, (note dont hit the legs they break.) (note: new spiders have metal center hubs, this is a common failure and the replacements have been ...

Ad

...spider and shaft, ensuring you remove any rust and debris; 12) Tap the new bearings into place. Again I used a hammer and firm tapping around the ring of the bearing; 13) Tap in the new drive shaft ...

Ad

Question about 23822 Top Load Washer

1 Answer

...shaft pull nylon spider off motor shaft install new spiders to shafts. Use a hammer to strike a wooden dowel on the center of the spider, dont hit the legs of the spider they break off Note the new ...

Question about 23822 Top Load Washer

1 Answer

...shaft or spider arms. If this is all one assembly, I would think Sears would be responsible for replaceing it under the lifetime stainless tub warranty, since the failed parts are not available ...

Question about 23822 Top Load Washer

1 Answer

...spider gear cross shaft and remove the shaft. push the axle in and remove the "c" clip on the axle end. It can then be pulled out of the housing. Reverse to install. Don't turn the gears while toe ...

Question about Elite 45986 Front Load Washer

1 Answer

...Kenmore Elite H3 washer. Can the spider be purchased without buying the whole basket? I ca not seem to find the spider and shaft by themselves. u can buy them seperatly. the shaft is part of the ...

...spider off of the shaft. any ideas. it has a cv type boot at the transfer case. How do i disconnect that joint to get the drive shaft off of the car. Maybe then I can beat the spider off of the drive ...

Question about 2004 Grand Cherokee

1 Answer

...spider gear cross shaft, sliding the shaft out of the carrier then pushing the axle in. The clip (actually just a "C" is easily removed and the axle then just pulls out.) careful not to turn the ...

Question about WM-2277HW Front Load Washer

2 Answers

...are shot, you will need to replace the rear outer drum ***'y and possibly the shaft/spider; (if the shaft is rusted to the inner bearing races). in any case; it's not a cheap and easy

Question about 2004 Grand Cherokee

1 Answer

shaft that retains the spider gears. Depending upon which design you have it's held in either by a bolt or roll pin at one end. Once the shaft is out, be careful rotating the carrier as the spider

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Washing Machines Experts

Brad Brown

Level 3 Expert

19187 Answers

Cindy Wells

Level 3 Expert

6688 Answers

john h

Level 3 Expert

29494 Answers

Are you a Washing Machines Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...