Questions & Answers for: Hyundai where is the speed sensor located on the transmission

speed sensor on a 01 hyundai santa fe? it is 2wd with a six cylinder. I was told the input speed sensor is under the air box and the output speed sensor is ''kind of'' under the master cylinder on the

...speed sensor where it is. looking for more info The output speed sensor is located on top of the transmission output shaft, this will send speed value to the transmission control module (TCM). The ...

...speed sensor, and there are several solenoid valves located inside the transmission connected to the valve body. Each and every one of these items can be a problem -- again -- depends on what the ...

...speed sensor relays located in the transmission? There are no relays in a speed sensor circuit. If you are talking about the relay itself, the output speed sensor is going to be in the extension ...

speed sensor where is it located? Hi The speed sensor is on the transmission. It is under the air cleaner box. The input and output sensors are located there too. They are attached by one bolt each ...

...speed sensor unit on my 2001 sante fee VECHICLE SPEED SENSOR ATTACHED TO THE OUT PUT SHAFT OF THE TRANSAXLE. Here is a picture of where the speed sensors (pulse generators) are located, there are 2 ...

...speed sensor Sensor located on transmission needs to be replaced, not a serviceable part.There are 2 sensors, the one located on top of transmission near the engine is the one that displays the speed ...

speed sensor Can I replace input speed sesor myself ? yes if you want to do it . locate it on the side of the transmission. it should be the only thing plugged into the front side of the transmission.

...in cluster on key on cycle but speedometer uses both vehicle speed sensor and right front wheel speed sensor to operate . Vehicle speed sensor is located on top of transmission near right axle ...

...Speed sensor. Known front right location. replaced sensor, cleared code, and check engine light goes on and same code of P0501. What gives? " Known right front location "? It sounds like you changed ...