Question about 1996 Town & Country
speed sensor Not work on a Automatic Transmission. The over drive will not work. The over drive is a SENSOR Located inside of the Transmission. On vehicles with 3.0 liters. On vehicles with 3.3 0r 3.8
...speed sensor to replace on my 97 town and country.speedometor very erradic and tranny not shifting correctly you need to replace the output speed sensor..located on front of transmission..near ...
...speed sensor on a 2006 chrysler 300? A wheel speed sensor? They are located at each individual wheel. An output or input speed sensor? They are located on the drivers side of the transmission. They ...
...speed sensor the input speed sensor is pretty easy to find. With the hood open and standing in front of the van you should see the transmission on the drivers side of the vehicle. look under the two ...
Question about 2002 Town & Country
...unit located on a chrysler town and country transaxle has two speed sensors input speed sensor located behind transaxle cooler lines the output sensor located far right transmission case driver
...speed sensor is located on the transmission. while standing in front of the vehicle and looking down at the transmission you will see two rubber hoses. under those hoses you will see the input speed ...
output speed sensor were is the output speed sensor located This vehicle uses a vehicle speed sensor located at the bottom of the transmission where the passenger ax;le comes out of the transmission
Question about 2007 Pacifica Touring
...transmission speed sensors please? See the diagrams. Output and Input are on the transmission housing. ...
Question about 2007 Pacifica Touring
...off and valve body pulled. one error (none told) for speed sensor NAG1, box. is 1 driver who drives with off on brake and throttle same time 2 foot drivers cause tranny brain to go nuts. cure is
Question about 2007 Pacifica Touring
...speed sensor and an output speed sensor. These sensors help the transmission control module (TCM) understand the speed of the input shaft and the speed of the output shaft, allowing the TCM to adjust ...
Usually answered in minutes!
1,229 Questions
1,289 Questions
1,198 Questions
1,079 Questions
1,173 Questions