Questions & Answers for: no speed control Food Mixers

...speed control board is stuck The switch on the phase control board/speed control board on my KitchenAid Classic Stand Mixer (max watt 250) is stuck on the "10" speed and it will not budge. The mixer ...

...speed control works: Speed Control The speed control of the mixer is attained through the use of a governor assembly mounted at the rear of the control plate assembly. The electrical circuit is made ...

...Speed Control lever is linked to the Speed Link mechanism, which in turn moves the Speed Control Assembly to allow the motor to operate at different speeds. Get a Repair Part List from Kitchenaid.com ...

speed control plate and a governor for speed control. the governor rarely goes out the phase control board is a likely culprit but the system would work only in high gear if it was

...speed control. Its likely that the speed control mechanism ( probably an electric one has been damaged due to ailing parts). Likely component which may fail over time are electrolyte capacitors. Take ...

speed control board. There is a primitive switch there operated by a shaft from your speed control lever. You may find the switch is not activating until it gets right up to speed 10. Have you checked

speed control and look at the speed control plate while operating the speed lever. Make sure the lever is moving the plate in and out. If yes then I would replace the small PCB above the control plate

...been fiddling about with the speed control adjustments? Possibly the small 4 wire PCB above the black control plate is unwell although normally it would give completely dead or every speed high

My mixer will only work on high speed why Speed controllers reduce the power provided to the mixer motor and have to "soak up" some of the power not used. If the mixer was used on low speed but heavy ...

...speed control and the circuit was fairly straightforward to check with a multimeter and any capacitors found are likely to be radio interference suppressors. Later mixers use an electronic speed ...