Questions & Answers for: Ford Excursion no speed control

Speed Control Senors frount and Rear. Where are they and why do I have to keep replaceing them? one is on top the rear diff, and the others are at the front wheels mounted to the hub they just wear ...

...control Fan is on all the time Fan is on high only It does not matter if it is AC, heat or Def. I am guessing it has eatc. The blower speed controller is shorted causing the blower to stay on all the ...

...control fan speed. The lower speeds generate more heat in the resistors and these tend to burn out. While it is possible the switch could be the issue, I would start with the resistors. It is usually ...

...2nd raw in the fuse panel (located below and left of the steering wheel) it is a 20 Amp Fuse Stop Lamps, Center High-mount Stop Lamp/Hazard, Trailer Tow Stop Lamp, Speed Control. All share the same ...

...speed control module. This controls fan speed in all ranges and sounds like it has internally shorted causing this concern. Hi there, Well the fan runs because engine gets to hot and even it's turned ...

...Speed Control, Page 01 (2002, System overview, Gasoline engines) Fig. Vehicle Speed Control, Page 02 (2002, System overview, Diesel only) Fig. Vehicle Speed Control, Page 03 (2002, Gasoline engines) ...

...my 2004 Excursion, I can turn off the AC/Heater fan what is the problem If it is eatc ,the blower speed controller is probably shorted to power ,causing the blower to stay running with the a/c

...speed control servo connector (5.4L and 6.8L gasoline engines). Remove the bolts and remove the speed control servo (5.4L and 6.8L gasoline engines). Disconnect the connector. Remove the blower motor ...

...Shift Interlock (BSI), ECM, Overhead Trip Computer (OTC), AUX A/C Components,  Speed Control, Vacuum Pump, Backup Lamps, Electronic Shift On The Fly Hub-lock Solenoid, Heated Seathope this ...

...speed control OFF switch while turning the ignition key ON, making sure the engine does not start and is not running. The speed control indicator on the instrument panel will flash once to indicate ...