Questions & Answers for: Dodge Avenger spark plug wires 95 dodge

spark plug location and socket size. I wanna change the spark plugs on my 2008 dodge avenger. I just want to know where the plugs are on it and what size socket i need to use. 2008+ Dodge Avenger 2.4L

Ad

...spark plug(s) or bad wire(s). also a corroded distributor cap or rotor. a vacuum leak, A bad or leaking fuel injector, Engine out of time and mechanical engine faults including Compression leaks and ...

Ad

...spark plugs located in a 2008 dodge avenger? They screw into the engine block. Open the hood and look for wires going to the block. Pull one wire away from the engine block. Below, is the spark

Question about 2008 Avenger

1 Answer

...with replacing spark plugs on a 2.7liter V-6? you would need to get the right spark plugs, remove the wire to the plug one at a time, remove the old plug, install the new one and replace the ...

...spark plug, in excess of 12,000 volts. This could be breaking down such that it is unable to provide the continuous voltage required. Are the two spark plugs always the same? If so, what happens if ...

...spark plug wires and spark plugs.First lets remove the distributor cap. This will allow use to inspected the rotor and the distributor cap. What your looking for is, cracks, carbon tracks and wear at ...

...to spark plugs. I don't have themaintenance manual, where can I get it quickly (download) First, have you tried anything? Avengers and Sebrings 95-00 are my specialty with this model. Write me

spark to plug wires, with an assistant, in drivers seat, pull off a spark plug wire from a spark plug, use a paper clip, insert into end of wire, with the helper turnning the key to crank engine, hold

spark to plug wires have replaced crankshaft positioning sensor and still no spark please help. You need to check wiring first. After that would be the ECM. You need wiring diagrams/pinouts and a volt

...plug wire spark 1997 dodge average 2.5 v6 24 value.have already replaced crankshaft positioning sensor on it and still no spark to the wires Sounds like a bad distributor. Had you pulled a spark plug ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...