How much oil should i put in my 2003 Honda crf230f, when changing the oil? And where is the drain plug You Should Always Fill Up The Oil Tank When You Put Oil In It, There Should Be A Couple Of Tubes ...
...mean engine is "stuck" If this is the case the engine is "seized" try turning engine over with a spanner on the drive sprocket. If no movement at all engine is seized.I assume that the radiator is ...
i over torq and broke one of the 4 nuts and stud on the lower right front fork, is the stud a reverse thread, i've got to replace the studs? No standerd treaded stud.
...nut with a hammer.A good tap. Next using the spanner that is captured behind the two nuts,try to loosen the nut (at the bottom of the stud). 9 times out of ten this works. If it doesn't tap the end ...
how do i get rear axle out of my 2005 honda crf 230 f. i need to put new chain and sprockets on. A diagram of the rear wheel assembly can be found at the website below. Just loosen the axle nut 1/8' ...
replace fork seal jack the bike up so it will be stable with the front wheel off of the bike. Take the caliper and fender off of the forks. Remove the wheel and loosen the tripple tree fork tube bolts
my 2005 crf 230f wont start it wont even attempt to turn over when i hit the button. i can on the other hand push start it. do i need a new switch If you are getting completely nothing no noises or ...
Question about 2004 CRF 230 F
2004 Honda CRF 230 F how much slack should the timing chain have I replaced the tensioner on my bike but I don't know if its suppose to be really tight or have a little bit of slack in it? please help
Why can't I find top dead center? I'm trying to check valve clearance. can't get t mark on compression stock, passes it up everytime. Help with the plug removed back the crank up if it slightly short ...
Usually answered in minutes!
59 Questions
50 Questions
50 Questions
2 Questions
2 Questions