Questions & Answers for: Volkswagen spanner nut

Question about 1999 Passat

1 Answer

...in the front. If the nut is too tight, you can use a spanner with greater leverage, or use you regular spanner, just extend it's leverage with a pipe or something of that kind. Good luck,

Ad

Question about 1999 Passat

1 Answer

...undo the nut holding the swivel onto the hub carrier. You will need a 17mm,18mm & 19mm open ended spanners to crack open the lock nut that secures the tie rod end onto the steering rack end. You

Ad

Question about 1995 Jetta

1 Answer

...covering comparment-Disconnect harness connector supply line and return line from flange-Remove screw cap with ring spanner-Remove flange nut and sealing ring from opening-Looseng fuel tank fuel ...

...nut at the bottom of them instead of the hex bolts, check to see if you have that type before starting, obviously you will need a wrench/spanner to fit it and the hex nuts if you have them..hope this ...

...fitted to the front hub on golfmk4. thanks very much S .A hope you have a set of metric wrenches/spanners.......you can measure across the flats of the bolt/nut to get the exact size

Question about 2002 Golf

1 Answer

...job just dirty ,and remember the clutch retaining nuts are 9mm with a star sort of shape so a ring spanner with the right shape is a must ,shouldnt take more than 3 hours with hand tools ,quicker ...

Question about 2002 Golf

1 Answer

...SPANNER WRENCH TO HOLD THE IDLER PULLEY WHILE TAKING A LARGE WRENCH TO LOOSEN LARGE DRIVE NUT.LIFT THE FAN CLUTCH ASSEMBLY PAST THE SHROUD THEN OUT OF THE ENGINE COMPARTMENT.NOW YOU CAN UNBOLT THE ...

nut on one of the heater plugs and the black to earth. get someone to turn on the ignition and you should get somewhere near 12 volts, it should go to zero when the light goes out. if this is what you

Question about 1994 Jetta

1 Answer

1994 VW Jetta 2.0 ,5 speed transmission, how do the adjustment cable work, need to adjust the clutch you adjust the clutch like this, using two spanners to undo the two nuts at the gearbox end of the ...

Question about 1994 Jetta

2 Answers

...spanner tool 3217, remove the fuel pump flange nut. Remove the fuel pump unit and seal. Installation is the reverse of removal. Be sure to use new sealing rings and/or gaskets. Tighten the fuel pump ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Volkswagen Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Bradley
Bradley

Level 2 Expert

105 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Volkswagen Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...