Question about 9"/230MM 5,000 Rpm Large Angle Grinder with 4 Hp Motor
...nut. If it is a diamond blade and you have already snapped a pin spanner then I would suggest securing the blade in a vice and using a set of stiltsons/pipe wrench. While in the vice you could also ...
Question about 7750 4 1/2'' Small Angle Grinder
...into the holes on the lock down nut. Hold the shaft with a open end wrench that fits the flats on the shaft. If you dont have the spanner wrench, use a drift punch to tap the lock down nut to
Question about 7750 4 1/2'' Small Angle Grinder
...spanner/wrench. It is like a tool with two pins that fit in the holes of the grinder disc securing nut. You can see a picture of one here: ...
Question about Black Decker Decker G750 4 12" Angle Grinder 6 Amp
...while turning the spanner wrench. If this fails what I have done to remove a "stubborn" wheel is use a punch UNPLUG TOOL FIRST and hit against one of the holes counterclockwise to loosen the
...Any help would be great. Thanks! give it a tip off a hammer and chicel will loosen it beter hit the ...
Question about Black And Decker 4-1/2" Angle Grinder 7750 2yr Warr
slide thin metal home made or not shim, sharpened & tapped in between the blade and the center nut. The idea is to make it one unit again. Later, put spanner on it to gently tap, counter-clockwise
Usually answered in minutes!
31 Questions
14 Questions
16 Questions
2 Questions
8 Questions