Questions & Answers for: spa temp incorrect

...spa in, it will shut down and read Sn on the topside control panel. We have replaced the high limit/temp sensor to no avail. If you jump the control panel the hot tub will run, jets and all, but it ...

temp sensor. spa is 88 degrees but master temp heater shuts off because it reads 104. what should i check? the thermistor/ If the Easy Touch is reading the correct temperature, but the heater is not -

temp sensor incorrect reading I have a Jandy Aqualink RS8 all button control system. Recently it started to read a high (108) temp. Replaced temp sensor and it still reads 108. What else could cause a

...jandy touchlink? if air temp is incorrect either bad temp sensor or check connections into plug at top of aqualink inside if off a couple degrees go into system set up and calibrate you get 4 ...

...30 degree check temp sensor if reading incorrect will keep shutting heater down or will not water up to full temp usually ohm out about 78ohms if temp sensor is ok sounds like heater element is ...

heater will not come on. The heater will not kick on. Have reprogrammed the Aqualink to 88 and the heater to 104 and have enabled the Aqualink to the heater. You need to put a volt meter on the wire ...

incorrect temperature Temp is about 25 degrees higher than measured bad temp sensor

display panel shows incorrect temp. display panel is 13 degrees lower than actual pool temp. bad temp sensor replace

Water temp is incorrect, reads 117 F. Air temp reads correctly. I have swapped the air and water probes but the problem stays with water. What should I try next? need new water temp sensor

...spa temp correctly, ignites and blows hot. Within seconds the temp. reading skyrockets and it all shuts down. Any ideas? The sta-rite (panel) has failed or was incorrectly installed. sounds like low ...