Questions & Answers for: solenoid part/page-2

page is fed, the solenoid lever returns to the open position, i.e. not stuck on the electromagnet... If it remains stuck on the electromagnet, the sheets keep feeding back to back and paper jam... You

...page-2.html#post55451This manual helped too...http://www.freeprintermanuals.com/PM/Kyocera%20FS-1010%20Parts%20Manual.pdfThis is the post...Success A solution has been found. Thank you to Steveauh ...

...read this to better understand and use the site for help. THIS SITE should help with the solenoid problem, fourth post down by NickR (should be the last on the page) Hope that helps, please rate

...page l;ast step) http://www.american-appliance.com/catalog/newsdesk_info.php?newsPath=12&newsdesk_id=34 Image of inlet water valve in the bottom rear of your unit. ...

...2 although no other paper size but standard is used. This is most likely the paper pickup or registration solenoid sticking open.you can remove the solenoid, clean the mating surfaces and install a ...

...page which would, of course, cause another pulse to energize the solenoid. I found it was due to a deteriorated thin half moon-shaped foam pad on the top of the solenoid's electromagnet that would ...

...replaced, 2.replaced paper feed mechanisam 3.replaced tray2 still same. Some times open and close tray 2 printer starts printing one page and show the same error. Clean the feed rollers. solenoid ...

hydraulic slide out will go out, but not in. reverse solenoid problem? or is it a problem with the brushes in the motor power to solenoid good in both directons, sounds like solenoid is engaging when ...

...2 wheel drive transmission automatic??????????????????????????? say what exactly there are 100s of pages just the tranny solenoid page? alldata.com has this. as does the FSM (factory serv.

page?
and there is not just one box solenoid/the word is solenoid's (MANY INSIDE IT,DEEP)
say my a/t box shifts funny?, late? or slips? or will not shift in drive,1,2,3,4,5 or sticks at 2.??????