...soldering iron and some acid core solder. Skin back about 1/2-3/4 inch of wire on each wire, add a peice of shrink tube, twist the wires together and solder them together, side the shrink tube over ...
...wire. Solder the wires back to the swtich in this order: Black - top Blue - center Red - bottom Start at the top and work down, and after soldering each slide the heat shrink tubing over the solder ...
Question about 2003 Outlander
wire of my headset had cut, I try to fix it but I cannot determine where the blue, red, yellow and green wire to connect to the four lines of the headset. You may have this posted in the wrong product
...wire. Solder the wires back to the swtich in this order: Black - top Blue - center Red - bottom Start at the top and work down, and after soldering each slide the heat shrink tubing over the solder ...
...wire. After soldering, let the wire cool down before covering the exposed wire with the heat-shrink. Then slide the heat-shrink into place and use the heat-gun to heat the shrink until you see the ...
...soldering wire for electronics, and put shrink tubes to protect the wires, put the shrink tubes on the wires before soldering together, and ensure the shrink tube is the proper size awg wire gauge. ...
Question about 1999 Taurus
...something you can buy so you can reconnect the wires As long as you have something to solder to, a soldering iron, flux and silver solder. Or take it to an electronics engineer, tv repairman
Question about 1999 Taurus
...wire cable from the circuit board. Can I re-attach that? Thanks Normally wires are soldered to the circuit board. Use a low temperature soldering pencil and rosin core solder. A small soldering iron ...
...wire to fill in the missing gaps It is just called a wiring harness, but they are a nightmare to replace because they usually go behind the dash and all over the place. You can fix it by splicing ...
Question about 2013 Avenger
Bluedio hurricane turbine left side snapped need help with circuit schematic Bluedio hurricane turbine left side snapped . I was able to open it but am not where to solder back the broken wires. Need ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions