...elements on an electric water heater? after you shut off electric and water and drain tank they are unscrewed. they make a large socket like wrench to remove i have also removed using a basin ...
...remove the bolts with a socket wrench. If the element is not installed with a mounting plate, remove with an element wrench. Step 3 Clean the gaskets and the gasket area on the hot water heater tank. ...
...remove element they have a tube type socket at hardware stores for the removal of it. Put elements in and fill water heater till all air is out of lines before turning power back on. make sure water ...
Question about 40 GAL ELEC TALL Water Heater 6YR SC 82VH402
...remove black and red lead wires from the element use a socket to un thread the 3000watt 240 volt screw in element. re install the new element atach wires to element. Fill tank with water before ...
Question about 40 GAL ELEC TALL Water Heater 6YR SC 82VH402
socket to remove element on electric water heater most of electric element is 1 1/2" socket. No need to hire pro , at www.bangslush.com they sell the element socket for only $ 14.95 with free shipping
Question about GE SmartWater Household Water Filtration System - GNWH38F
...remove with socket if it is that type of element or 4 bolt type. Upon starting putting it all back together remember to open all faucet's hot side to purge out all air out of system before turning ...
...remove elements with a 1 1/2 " element wrench or socket. Replace elements and connect electrical and turn water back on and leave the faucet open to get all air out of system and water flowing from ...
Question about & Lowboy& Electric Water Heater
...remove the heating elements by removing the two wires and using a water heater socket (or 1 1/2 inch socket if you have a big socket set) and replace them. As a side note, if you have removed the ...
Question about & Lowboy& Electric Water Heater
...following link for removing old element:Water heater needs to be about 1/2 full of water. Use 1-1/2" socket from automotive ...
remove bottom heating element using a special large socket. Visual inspection should tell you if it is melted. If it is ok check the top heating element. If the heater was on and the tank not full the
Usually answered in minutes!
335 Questions
282 Questions
267 Questions
250 Questions
267 Questions