lamp (reverse lights) are not working. Replaced bulbs. Worked once then quit. Cleaned out bulb receptacles. One bulb worked but the other did not . Bought another set of bulbs. Nothing is working now.
Recently I had repairs done on my car. My v belt broke and I had my brake pads replaced.I had not driven my car at night until a day after the repairs, only to find out my headlights were out. Now I ...
rear lisense plate lights not working I have two of these vehicles one 96 one 98 can't figure out the lisence plate lighting, popo kind of requires this in wisc. check the bulbs, it takes a standard ...
the bulb on the passenger rear turn signal keeps burning out and the socket that it fits into looks kinds melted #04083: Product Safety - Rear Stop/Turn Signal Lamps Inoperative This is a safety ...
lamp. Bulb from the socket. To Install: Install or connect the following: Bulb to the socket. Bulb/socket to the side marker lamp. Side marker lamp to the front and/or rear bumper fascia. Screw to the
socket. Cannot find a specific fuse that serves the licence plate lamp (owner's manual, on-line forums, etc). All other lights on vehicle are working including dash, so fuse appears to be stand alone.
1998 PONTIAC SUNFIRE, WHEN TURNING ON HIGH BEAMS, PASSENGER SIDE LIGHT SHUTS OFF COMPLETELY, CHANGED BOTH LAMPS. STILL SAME PROBLEM IS IT THE HARNESS... LOW BEAMS WORK FINE Could be the harness, the ...
...lamp socket through the trunk. Once you open the trunk lid look for an access panel or the accessibility by pulling the carpet back to expose the different lamp sockets and wiring harness. Locate the ...
Usually answered in minutes!
987 Questions
731 Questions
699 Questions
696 Questions
696 Questions