Questions & Answers for: GMC Envoy XL socket for lamp

...cap on the rear side of the assembly, the top cap is for the low beam, remove cap and turn bulb socket CCW to release socket. Unplug old bulb and install new, DO NOT touch bulb glass. Re-assemble ...

...also it has 105,000 miles [email protected] take the breather off  and take a 10 mm socket to take the coil off easy to get to then take a 5/8 plug socket to take out plugs easy to

had to jump start car several times battery and altornator check ok. now what? you may have a leakage.. This means that when you turn the vehicle off, something is staying on !! Check to make sure ...

brake lights won't work. tail lights do. I brake lights won't work. tail lights do. I checked both fuse boxes and fuses are good. It is a 02 gmc envoy. I also checked the bulbs and both bulbs on both ...

my 2007 Envoy low beam do not work but the fog lamps and the high beam dose work. two possibilities. your lights are bad or you have a bad hi/low switch. i would check the lights first.

lamp connectors with electronic contact clearer. Also, I didn't find any burnt stains inside or outside of the connector. What can I do to fix the driver's side marker and parking lamps? If you have a

My GMC 2003 Envoy failed smog test because of "the My GMC 2003 Envoy failed smog test because of "the MIL/Check Engine Light Test due to Warning Lamp Failure". I was told the check engine ...

my 2004 envoy back Auxilary power outlet is not working it wont give any power check fuses and socket outlet. you might have power going to it from before the socket but socket could be faulty. if not

2 out of 3 brake lights dont work At the underhood fuse block, check 25A ST/LP fuse 12 which feeds power to the stoplamp switch. If OK, go to the rear fuse block and check the 10A VEH CHMSL fuse ...

2003 GMC envoy XL...tail lights work but brake lights will not work is it the brake light switch and how can I test it ST/LP, Fuse 12, 25 Amp - feeds battery positive to brake switch ORN (orange) and ...