...lamp anyway and still doesnt work. all other lights on van work so fuse chould be ok. where do I start to track down problem? could be the socket where you put the bulb or the wire that goes to the ...
Question about 1999 Windstar
...the connector and bulb. Remove the bulb from the socket/connector and install a new bulb. I think the number is 3017. Be patient and do the reverse to reinstall the large lamp assembly. Good
...lamp, middle of the three lights (on when headlights are on) is out. I have swapped bulbs, and the bulbs work on the other side. I've swapped sockets, to the same effect. I've gone after this with a ...
1999 windstar sel. left rear tail light inop. i replaced,bulbs both sides and sockets both sides have 12volts both sides. cheched all grounds. and at REM module ,when i back probe the 3 wires at ...
lamp socket.turn socket counterclockwise,remove & replace bulb.do not touch glass of a halogen bulb,the oil from your fingers will cause a 'hot spot' & bulb may fail prematurely.clean 'touched
...lamp socket and see if it's getting power. If it is, the socket is bad and should be replaced. If it's not getting power there may be a break in the wire, you will have to follow it back and try and ...
socket in lamp . Secure lamp to rear license plate lamp shield with two screws and tighten to 2 Nm (18 lb-in). ItemPart NumberDescription 1 13508 Rear License Plate Lamp Shield 2 14A583 Lamp Lead Wire
...then slide it out of the lamp assembly. Carefully pull bulb straight out of the socket and push in the new bulb. To complete installation, follow removal procedure in the reverse
lamp. Remove the connector from the headlight bulb and see if it's burned or melted. Similarly for the lail light, but in this case, reach in thru door in back and turn socket CCW to release from lens
Usually answered in minutes!
1,830 Questions
1,838 Questions
1,503 Questions
1,212 Questions
1,032 Questions