Question about WD-52725 52". Rear Projection HDTV
...hear a distictive buzzing sound coming from the lamp area. on that model its possible for the lamp sockets from the ballast get pushed back inside the tv. Remove the bulb and verify that the sockets ...
...case are the CRT sockets this are the socket that connects the cathode lamp and the CRT board it is place at the tip of the cathode lamp..just replace them with a new one and the picture will be
Question about WD-Y57 57" Projection HDTV
(it is possible when inserting to not get the two pins lined up correctly.The lamp cartridge has to be installed precisely so it plugs into the socket and also the lamp door must be closed and secured
Question about WD-60738 TV
...socket out of the way---remove lamp and take a good look.Another issue with these sets is dirt.I will provide here a link for one question I answered here (there are several but one is enough) ...
...seen ones where the two pins on the lamp cartridge bend the two pin socket aside and no connection.Look to see socket where lamp plugs is secure and not bent away and lamp is installed
...issue on this brand is when putting the lamp in the socket that it engages gets bent or shoved to one side---with lamp out look to see if the two pin socket the lamp plugs into is not bent
...socket fitting on the new lamp is held in a fixed place in the lamp housing by a small philips screw. When this screw is loosened the male socket fitting position can be adjusted. In my case I had to ...
Question about WD62628 62" Projection HDTV
...socket the lamp engages did not get bent or moved to one side--if so it has to be got at from inside and the rear-----one tiny screw usually holds it in place----you should be able to see if socket ...
Question about WD-62526 Projection TV
...lamp bend the socket a little out of position and lamp does not go in correctly---from the inside rear two small screws hold that socket in position--in this case what I do is loose or remove the ...
need to know reading lamp bulb size Marked on the lamp is the # You can print an automotive lamp chart off the internet also & match up the lamp size,socket base, current & such
Usually answered in minutes!
1,423 Questions
661 Questions
607 Questions
562 Questions
482 Questions