...socket to undo nut. The paasager side door front motor took a dump and the track holding the window rivets came out. 4 muffler systems complete from the exhaust manafold to the rear tail pipe. the ...
...from the vehicle. Disconnect the rear combination lamp electrical connector. Remove the four bulb sockets from the rear combination lamp assembly and remove the four bulbs from the sockets. To ...
lamp lights when I turn the headlights on but goes off if either the right turn signal or the hazard flasher is activated . The dash indicator flashes quickly as does the rear tail light on that side.
Question about 1995 Tracker
...the acid test. that. any volt meter does that in 5min flat. 3rd brake light is bad bulb or corroded socket. what tranny< 3,4,5,sp.? but in each case it takes a good rev. switch, if 12v enters said ...
...lamp socket is fixed the door switches will have chance to work. are you in the salt belt? (no location stated, on earth) canada? N. USA? east coast, all use SALT as does G.lakes. an other
...lamp is bad. (used lamps can have a shorted base so only NEW lamps work best) the socket is bad. (corroded the wires are cut by trailer hitch goons, (wire hackers (look and see) its not the fuse or ...
...socket for rust, corrosion, etc. Replace if needed. Check and replace the fuse as well as the turn indicator relay (this is under the dash). To find it, turn on your blinker (left or right) and feel ...
...screws from the license plate lamp assembly. Remove the license plate lamp assembly. Remove the socket from the lamp assembly. Remove the bulb from the socket. Installation is the reverse of
Usually answered in minutes!
421 Questions
350 Questions
286 Questions
276 Questions
239 Questions