Questions & Answers for: Ford socket for lamp

...lamp anyway and still doesnt work. all other lights on van work so fuse chould be ok. where do I start to track down problem? could be the socket where you put the bulb or the wire that goes to the ...

...socket to the lamp assembly - don't forget to lock the socket into place by turning it about 1/4 turn (clockwise). Then return the lamp assembly to it's correct position on the truck and secure by ...

lamp in socket at a time. DO NOT install sockets into fixture at this time. Test. Remove first lamp to check second. If still O.K., each socket back into fixture(one at a time same as before)and test.

...vehicle. #4 Remove the bulb socket by rotating it counterclockwise, then pulling it out of the lamp assembly. #5 Pull the bulb straight from the socket. Install new bulb(s) in reverse order. Good ...

...lamp socket and rotate it 1/4 turn. Pull the lamp socket from the lens. Pull the bulb from the socket Installation is the reverse of the removal procedure. Exploded view of the rear license plate ...

lamp assembly socket. It may take some effort to remove the lamp because it has a rubber o-ring type seal - try a bit of wiggling side-to-side Insert new bulb into headlight assembly - don't touch the

socket in lamp . Secure lamp to rear license plate lamp shield with two screws and tighten to 2 Nm (18 lb-in). ItemPart NumberDescription 1 13508 Rear License Plate Lamp Shield 2 14A583 Lamp Lead Wire

...lamp socket and wiring (13410) assembly 1/2 turn counterclockwise and remove from parking lamp (13200) housing. Remove screw from park/turn signal housing. Using 1/4 inch drive socket extension and ...

...socket from the lamp assembly. Remove the bulb(s) from the socket by pulling the bulb straight out. The installation is the reverse of the removal. Remove the trim clip center retainer and... ... ...

...lamp socket, or bad 12 volt wire at / between the common passenger 12 volt brake light wire in the harness to the center contact on the brake lamp socket. My suggestion is if the brake lamp wire is ...