Questions & Answers for: Dodge socket for lamp

...blinking when the hazzards are on inside or out. CHANGE THE SOCKET FOR THE BULB THATS FAILED ALSO CHECK THE TAIL LAMP ASSY, THE CONECTOR ON THE LAMP MAY BE DISTORTED AND NO CONTACT TO THE

...anyone let me know what I need to do???? Thanks a lot. On the back side of the lamp assembly, there is a rotating clip socket that holds the lamp socket in place. Rotate ¼ turn to the left to

...bulb socket from lamp. Pull bulb from socket. INSTALLATION Install bulb into socket. Install bulb socket into lamp. Place lamp in position. Install screws attaching license plate lamp to rear

...socket into the lamp. Insert the wire harness through the hole in the lower deck panel. Install the wiring harness grommet into the lower deck panel. Place the tail lamp into position on the vehicle. ...

...lamp bulb socket twist it counter clock wise then remove the socket and bulb unplug your old bulb replace with your new bulb and replace the socket back and clock wise tighten.Now turn your head ...

...socket Tail lamp from cargo box To Install: Install or connect the following: Bulb in socket Socket in tail lamp Tail lamp in cargo box to engage retaining studs Tail lamp screws Negative battery ...

socket causing a short. Next you may need to check the actual switch for a short, but start with the simple stuff. If in doubt, unplug each lamp front and rear one at a time to isolate if any one lamp

socket set. Pull the tail lamp assembly away from the body of the Stratus. Grab the socket for the bulb in question and twist it counterclockwise to remove it. Pull the old bulb out by hand and insert

...remove two wing-nuts, pull on the lamp assembly and push on the wing nut studs to remove lamp assembly. The bulb socket twists out of the lamp assemble. Replace the bulbs. replace lamp

lamp socket. One side is the hot terminal from the flasher system. The other side is a chassis ground. Most likely the test lamp will flash. If it does, you just need to run a new ground terminal from