Questions & Answers for: Chauvet socket for lamp

Have 2 Chauvet Intimidator Spots. 1 no longer projects light and the bulb is not the issue. It powers up, goes thur its start up routine but will not light the bulb This unit got a 24volt lamps that ...

...WHICH I LOST AND THE WEB SITE WERE I COULD BUY ONE If the power connector on the back is a 3-pin socket then get a standard IEC power cable. If it is a small rounded socket then get the ...

Where is the thermal fuse located on the Follow Spot? Follow the wires internally. Close to the lamp you will find part of the wire that looks covered in another shield or wrap. Usually the thermal ...

have a q-mix chauvet stage light goes thru all motions but light wont come on even changed bulbs and fuses alright Chauvet uses a 16 amp Triac to control the power to many of the 120 volt lamps in ...

I can see a smaal current going trough the bulb but it doesnt fire regularly It is important to understand how strobes work. A capacitor is charged to around 300 volts through a high value resistor. ...

...lamp socket as the wires are permanently attached to it. I found the sockets online with Google searching for "Socket XX" where XX is the type of lamp specified on the units. They are not expensive ...

...ALSO search Ebay for "socket XXXX" where XXXX is the lamp

device powers on and goes through startup but no light. lamp is new. scanner moves but no light Yep... I got one on the bench and also another I have just fixed. The one that is still sick has a lamp ...

...light. I have 6 of these in my lighting rig, and the most common problem has been a bad bulb socket. If your bulbs end up with corroded or blackened terminals, you should replace the socket. ...

The bulb and fuse keeps blowing out at the same time Verify that you have the correct fuses and lamp. install the fuse(and only the fuse,no lamp) and fire it up.listen for the fan.if the fuse holds ...