Questions & Answers for: Nissan Maxima slip light on

...SLIP light on hte dash board on. I dont know if the two are related but can anybody help me sort this out please. Removed the positve and negative charge of battery for 10 minutes then, plug it back ...

...light comes on at the same time as SLIP and TC off. If I turn ignition off and then back on SLIP & TC off goes away but Service engine light still on. Car runs great otherwise. I had the same ...

...slip light come on sometimes. when the tcs and slip light come on and i go to stop my car it runs very ruff but it doesnt do that all the time. Do u know what the problem might be. I also just had a ...

TCS, SLIP and ABS lights on TCS, SLIP and ABS lights go on after starting the car and remain on. Check your brake fluid first. If that is low, top it off and recheck. If its ok, than you will need one

i am planning to buy a nissan maxima.but the seller said the ABS.TCS and slip lights are on which is making the tranny to slip a bit. is this true. 1. why would the tranny slip? 2. why also are those ...

...SLIP is traction control. Most likely you have a speed sensor issue. Be aware, some vehicles can falsely illuminate TCS because of low tire pressure in a single wheel. i have 97 maxima trouble code ...

slip light on my nissan maxiam There is a Service Bulletin for a "SLIP" light on a 2000 Maxima. It requires the ECM to be reprogrammed. You will need to see a Nissan dealer for this concern. ...

...slip, vdc, brake & check engine light stays on. Any suggestions! Had the same problem ****** slips, had to rebuild transmission. My car ride gd but after Long period of time The transmission slip ...

The ABS, TCS OFF,and SLIP warning lights are on in my 2000 Nissan Maxima. What's the cause and fix? The ABS, TCS OFF,and SLIP warning lights are on in my 2000 Nissan Maxima. What's the ...

...slip light on what's that mean? The slip light illuminates when a traction control component fails or sends incorrect info to ecm. Normally problem is at wheel speed sensor, DO NOT REPLACE SENSOR ...