Questions & Answers for: slip knot

...hay baler is knotting twine twice and won't release from bale hook. Your timing belt has slipped. If you have the repair manual for your baler, this is a relatively easy

...slip knot against the outside of the housing to hold it in place and reassemble everything. Hook the end of your rope through the rope guide on your handle if it has one, slip the handle on and tie a ...

about the thickness of a shoe lace and made a slip knot loop around the remaining cord. (the plastic bit was still attached and the knot pulled up against this). this has been working fine ever since

...line all the way through, down to the knot. Catch the free end and put a slip knot in it, so it can't whizz on back into the reel. Attach the pull handle, and release the slip knot. Best regards, ...

...roop through all holes you need to go through, into the reel knot, i burn the knot, keeps it from slipping out,then slowly let the spring bring the slak in when i release the vise

...rope threw both holes knot the end threw the pulley hole slowly let the spring rewind the rope into houseing until it stops pull 1 foot out cut hold on to it slip threw your handle and knot it all ...

...slip new rope through houseing hole and pull hole put a screw driver threw houseing and pulley to make it so it cannot unwind then not the pulley end of rope take a lighter heat knot this will make ...

...knot off the end of the rope in the slot on the disk. slip the new rope in the hole on the metal housing and through the hole in the plastic disk. tie a knot in the end of the rope and push it in the ...

...slip your knot on the reel spool, tighten it, and then reel in. A more efficient way may be to install your reel on the rod, first pass your line through the first guide, and then do the same things. ...

...line will not seat itself so it will reel the line in! You mean how to tie a knot around the spool so it won't slip...two double overhand knots... sometimes a SMALL piece of cellophane tape will