Questions & Answers for: kawasaki VN 1500 Vulcan Classic slip clutch

...clutch seems to slip, and the bike starts to move but only at a walking pace 10mph. Engine power and throttle good. Once I have traveled about 1/2 mile and shifted up into fourth gear (engine very ...

1995 vn1500a9 clutch slips new clutch (suposibly) original master/line/slave....late clutch to begin with and slips....bleeding helps...but only temperary....any suggestions? if the bleeding ...

...CLUTCH SEEMS TO SLIP IN ANY GEAR 1997 VULCAN CLASSIC WITH NEW CLUTCH SEEMS TO SLIP WHEN I CRANK THE THROTTLE IN ANY GEAR. MECHANIC SAYS THE CLUTCH IS DESIGNED TO DO THAT. IS THERE A REMIDY OR DO I ...

...is top speed on a vulcan1500 A 1996 because there is no tach? sounds like your cluch heats up and slips like a pig when it gets hot time to do a visial on the cluch buy the manual and start ...

...out the clutch master cylinder and slave cylinder with fresh dot3/4 brake fluid. If the clutch is slipping the clutch spring may be worn in the center. It is a diaphram spring. They wear against

Clutch will not slip now. I just had the same problem and changed clutch spring, plates, etc and nothing worked until I did this. Almost sounds like you have 2 problems. Check in order #1 then 2 1.Air

...clutch is begining to slip when cold. Seems ok after riding for about an hour. It also clunks, or grinds when shifting from 1st to 2nd, and neutral to 1st. Also, when downshifting, you can feel it ...

At low speed and taking off I have no problem with a slipping clutch, but at high speed about 100km + and hour, if i give it some gas it slips then it seems to ease off, I also don't seem to have much

...when releasing clutch lever only 1MM.... But once im riding i can pull hard on any gear without slipping so i know its not the clutch... Ive already blead the master cylinder and there was alot

CLUTCH slips on 2004 vulcan CLUTCH SLIPS WHY?? clutch adjustment or worn clutch plates will cause this , check adjustment ok then if no change replace plates !