Questions & Answers for: Ford Focus slip clutch

...transmission? I didnt think it would cause it would make the fly wheel slip but i just wanted to make sure. The clutch operates dry. Your assumption that it would slip with oil in there is a good

...clutch going? i sure it doesnt slip its had a city life and done 75000 KM. you say it doesn't slip ,pull hand brake hard, start engine put it in fifth gear accellerate and let clutch out if it dies ...

...engage reverse. gears clash, fading gently to silence.... engage and drive off normally, no sign of slipping. On move, low rev changes easily done, but more energetic accelleration causes sticky ...

Burning clutch smell yet clutch not slipping WE have a Ford Mondeo 2.0 tdci 53k miles. 2005 After reversing our caravan into our drive last week (which is up a slight slope) we noticed a very bad ...

...my car doesn't get up to speed possible clutch wear , if the clutch is worn, adjusted wrong, or slipping, this same thing will happen, depending on how many miles are on your vehicle, it may be ...

is a clutch master/slave cylinder problem. The high revving and not going normal speed, is a clutch slipping problem. try replacing the master and slave cylinder, bleed to lines, and see if that fixes

2003 FORD FOCUS CAN'T CHANGE GEAR BUT CLUTCH IS NOT SLIPPING CAN'T CHANGE GEAR BUT CLUTCH IS NOT SLIPPING if clutch not slipping, problem is in the shift linkage or cable could be ...

...clutch to slip, what could be the cause of that? it started doing this a couple days ago, one minute the car is perfectly fine, then all of a sudden, like i said, it'll start jerking really ...

slipping clutch master cylinder brokeon my clutch. was no leaks just the plastic bit had snapt. changed it and now my clutch is slipping. cud it be air inside. it was fine b4 i changed it That could ...

...clutch half way and then immediately take you foot off of it. It should engage immediately and should not slip. If it takes more than a second or two for it to fully engage, the clutch parts are